Installing a 240 Volt Circuit Breaker
By Bob Formisano, About.com Guide
Connect Wiring to the Circuit Breaker
Connect the two hot leads to the circuit breaker. Make sure the connections are tight or the circuit will overheat and the breaker will pop.
© Home-Cost.com 2007Next, connect the two black hot leads to the circuit breaker. Make sure to insert the wires fully into the screw terminal and tighten securely.
Prev
- Introduction
- The 240 Volt Twist Lock Plug and Receptacle
- Remove Panel Face Knockout Tabs
- Inside the Panel: How a 240 Volt Circuit Differs From 120 Volt
- Strip the Wire Ends
- Connect Wiring to the Circuit Breaker
- Install the Circuit Breaker
- The Installed Circuit Breaker
- Install the Ground Wire
- Terminate the Circuit Wiring at the Receptacle
Other Must Read Home Repair Tutorials
Anatomy of an Electrical PanelElectrical Boxes 101Why Breakers Trip and Fuses Blow
Explore Home Repair
Must Reads
About.com Special Features
Holiday Central
What to eat, where to go, fun things to do and how to save money on the perfect gifts. More >
Make Your Own Scented Pine Cones
Bring a little of the fall season in your home with this easy-to-make craft. More >
©2009 About.com, a part of The New York Times Company.
All rights reserved.